< Previous | Contents | Next >
T.1.1.1 The template shown below must fit into the cockpit opening
T.1.1.2 The template will be held horizontally, parallel to the ground, and inserted vertically from a height above any Primary Structure or bodywork that is between the Front Hoop and the Main Hoop until it meets both of: ( refer to F.6.4 and F.7.6.1 )
a. Has passed 25 mm below the lowest point of the top of the Side Impact Structure
b. Is less than or equal to 320 mm above the lowest point inside the cockpit
T.1.1.3 Fore and aft translation of the template is permitted during insertion.
T.1.1.4 During this test:
a. The steering wheel, steering column, seat and all padding may be removed.
b. The shifter or shift mechanism may not be removed unless it is integral with the steering wheel and is removed with the steering wheel.
c. The firewall must not be moved or removed.
d. Cables, wires, hoses, tubes, etc. must not impede the template
During inspection, the steering column, for practical purposes, will not be removed. The template may be maneuvered around the steering column, but not any fixed supports.
For ease of use, the template may contain a slot at the front center that the steering column may pass through.